Making sure that moving from one point to another is easy, a vehicle equips users with an array of benefits. Not only does a car enable you to make your travel plans easier, but it also ensures that your daily commute is no longer a hassle. From near locations to far, a car can help you get to the destination of your choice within no time. This is why it is best to make sure that you take up timely repairs and maintenance checks for the vehicle.

Like any machine, a car also requires timely upkeep and maintenance. Without attributing enough time for its repair and replacements, users are bound to find a slew of issues in their car in the long run. This is why it is best to take your car to a dedicated garage or auto shop to fix Brake Pad Replacement Wokingham repairs. While annual car service is a great way for your car to receive its needed repairs, there are some issues that may not follow in the same line.

Brake Maintenance

As a seminal part of the car, brakes require inspection from time to time. The brake pads of your car exert friction on the brake rotors, which further propel the vehicle to slow down. This routine goes on normally until the heat and constant friction between the parts start deteriorating the condition of the brake pads. This is when you need to take the condition of the brake pads into account and think about a replacement.

How to Replace Brake Pads

You can head to an auto shop and ensure that the requirements of your brake pad replacement are met easily. Most manufacturers and experts suggest that a car’s brake pads should receive a replacement every time your vehicle goes over 25,000 to 50,000 miles. So, the next time you start noticing squealing or squeaking from your brakes, that means it is time for a brake pad replacement. In most cases, users decided to head to their nearest garage to ensure the process was done. Otherwise, there are other methods you can employ of your own volition to take care of the matter at hand.

The first step in replacing brake pads includes removing the vehicle’s brake fluid. By lifting the pilot cylinder, you can remove the excess brake fluid from the system. You can redirect it to the master cylinder pool by using a siphon or turkey baster before lifting the vehicle.

The second step requires you to lift your vehicle with a jack that can sustain high capacities of weight. You will have to position your vehicle in the correct way, which will allow you to go underneath the car. If you are unsure of the the jack points in the vehicle, you may refer to the user manual and begin your replacement process.

Next, it is important to inspect fluid leaks or grease leaks from the rotor and the calliper of the brake system. If there is a sign of rotor damage, you will have to undertake its maintenance, too. Next, checking the brake lines to look for signs of leakage and damage is pertinent.

After you have done the preliminary examination, you can pull the calliper bolts that hold the brake pads. However, make sure that the vehicle is not swinging or unsupported. Next, support your brake calliper by taking a cord and connecting it to a brake component. This will allow you to pull out the brake pads that have run its course from the site.

Having pulled out the brake pads, it is time to inspect the bolts, directions, and rubber boots to check for wear. After this, you will have to take the vehicle calliper and make sure that it can glide on the carriers. This will ensure that you can retract the vehicle’s calliper piston and put in new brake pads.

To do so, you can take a special brake pad spreader that will allow you to push back the piston into its position and release the brake pads. After this, you will have to deal with the extra brake fluid that will come into the head cylinder pool and cause the mechanism to overflow. You can use the brake pad spreader to spread the brakes and take out the old pads that are no longer in use.

Your new brake pads should be identical to the brake pads fitted in the vehicle earlier. It is important to make sure that the two are identical since it can affect the process of fitting. Even the backing plates should have the same shape. Finally, to complete the process, you can finish installing the brake pads into the calliper, restore the calliper to its place and align the mourning pins. The last step includes putting the bolts and pins back in their position.